Franke SLIM45 Manual De Instalación Y Servicio página 9

Plumbing connection
If dishwasher and/or overflow is not to be
connected go on to next section.
If you are utilizing a dishwasher, this should
preferably be connected directly to the relevant
connection in the siphon. If a dishwasher
connection is not available in the siphon,
complete the following procedure:
1. Using a blunt instrument (steel punch or
wooden dowel), knock out entire plug
(fig. 2A). Do not use a screwdriver or sharp
instrument. (When knockout plug falls into
disposer, you may remove it or grind it up
when the disposer is used. This will not
damage the disposer in any way, but may
take some time to grind).
Installation of mounting assembly
3
Sink
Reset
Button
SLIM45 / SLIM50 / SLIM75 / SLIM75BF / SLIM100 / SLIM125
Removable
Splash Guard
Sink Flange
Groove
Rubber Gasket
(or plumber's putty
-not included)
Flat Gasket
Support Flange
Upper Mounting Ring
Mounting Screw
Retainer Ring
Cushion Ring
Lower Mounting Ring
Elbow Pipe
2A
Dishwasher
Connection
Overflow
Connection
Siphon
Connection
2. Connect overflow hose (fig. 2B) using hose
clamp. If hose size is different, you need a
stepped rubber adaptor.
3. Connect dishwasher hose (fig. 2B) using
hose clamp. Make sure all plumbing
connections are tight and in accordance
with all plumbing codes and ordinances.
Run water and check for leaks.
Note: The mounting components are
assembled out of the box in the same order they
will be assembled on the sink, so please pay
close attention to the order of the mounting
system components before you disassemble
them.
1. The cushion ring and the lower mounting
ring will remain attached to the disposer
during installation. Disassemble the other
components of the mounting assembly by
rotating lower mounting ring clockwise until
the lower mounting ring tabs slide off from
the upper mounting ring ramp. This will
allow you to separate the upper assembly
from the remaining lower mounting
assembly.
2. Unscrew the 3 mounting screws until the
upper mounting ring can be moved to the
top of the support flange. Remove the
retainer ring with a screw driver.
3. Keep the remaining parts placed together in
the order they were removed. Before you
connect the disposer to the mounting
assembly under the sink, make sure the
lower mounting ring is in place and the black
cushion ring is still engaged properly to the
9
2B
Dishwasher
Hose
Overflow
Hose
EN