Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
Store the product
•
Clean the product before storage.
•
Make sure that the motor is not hot when you store the product.
•
Make sure that the product does not have loose or damaged parts. If it is necessary, do these
steps / instructions:
-
Replace the damaged parts.
-
Tighten the bolts.
•
Store the product in a dry area.
•
Make sure that children cannot reach the product.
TROUBLESHOOTING
PROBLEM
The motor does not
start when you pull the
trigger.
The product smokes
during operation.
The motor is on, the
auger bit does not
move.
There is too much
noise and/or vibration
during operation.
POSSIBLE CAUSE
The battery is not installed
tightly.
The battery is out of power.
The product has damage.
The product has damage.
The auger bit is blocked.
The parts are loose.
The parts have damage.
CORRECTIVE ACTION
Make sure that you tighlty install the
battery in the product.
Charge the battery.
1.
Immediately stop the product.
2.
Remove the battery.
3.
Contact the service center.
Do not use the product and contact the
service center.
Remove battery then clear blockage
from the bit.
1.
Stop the product.
2.
Remove the battery.
3.
Inspect for damage.
4.
Check and tighten loose parts.
Do not use the product and contact the
service center.
16
Publicidad
