Publicidad
Idiomas disponibles
Idiomas disponibles
5
ASSEMBLY
Always be sure that the tool is switched off and the battery pack is removed
before carrying out any work on the tool. Failure to switch off and remove the
battery pack may result in serious personal injury from accidental start-up.
Never start the tool unless it is completely assembled. Operation of the tool in a partially
assembled state may result in serious personal injury from accidental start-up.
There is a danger of explosion if the battery is incorrectly replaced. Replace only
with the same or equivalent type.
5.1 CONNECT THE POLE SAW ATTACHMENT TO THE POWER HEAD
Never attach or adjust any attachment while the power head is running or with
the battery installed. Failure to stop the motor and remove the battery may cause
serious personal injury.
NOTE: This hedge trimmer attachment is designed for use only with GREEN MACHINE
Power Head GMMT6200-PH.
1.
Remove the tube protection cap before installation. (Fig.2A, 1)
2.
The hedge trimmer can be attached in either the top cutting position or the side
cutting position. Choose the suitable position for the task (Fig.2A).
3.
Loosen the wing knob. (Fig.2A, 2)
4.
Align the installation hole on the hedge trimmer attachment shaft with the arrow on
the power head shaft and push the hedge trimmer attachment shaft into the power
head shaft until you hear a "click" sound, which means that the hedge trimmer
attachment shaft is mounted into place. (Fig.2B, 1)
5.
Try to rotate or pull the shaft to ensure the installation is secure, if not, reassemble it again.
6.
Tighten the wing knob firmly. (Fig.2B, 2)
Top cutting position
2
1
Side cutting position
Fig.2A
Page 12-English
2
1
Fig.2B
GREEN MACHINE 62V CORDLESS HEDGE TRIMMER
5.2 CONNECT THE EXTENSION TUBE BETWEEN THE HEDGE TRIMMER
ATTACHMENT AND THE POWER HEAD
Never attach or adjust any attachment while the power head is running or with
the battery installed. Failure to stop the motor and remove the battery may cause
serious personal injury.
Make sure the tool is firmly secured before operation. Failure to secure the
attachment and power head/extension pole as instructed above could result in
serious injury or death.
NOTE: This extension tube is designed for use with GREEN MACHINE Power Head
GMMT6200-PH and GREEN MACHINE Hedge Trimmer Attachment GMMT6200-HTA. The
extension tube extends the cutting range. It should be connected between the Hedge
Trimmer attachment and the power head. Follow the process in the section "5.1
CONNECT THE HEDGE TRIMMER ATTACHMENT TO THE POWER HEAD" to install the
extension tube between the pole saw attachment and the power head (Fig. 3).
Power head
GREEN MACHINE 62V CORDLESS HEDGE TRIMMER
Pole saw attachment
Extension tube
Fig.3
Page 13-English
Publicidad
