Publicidad
Idiomas disponibles
Idiomas disponibles
Option 4 – (No Garbage Disposal - No Air Gap):
IMPORTANT: If you need to cut the drain hose to fit the diameter of
the connection, cut only the rubber end of the hose, as shown earlier in
this section (do not cut into the ridged section).
1.
Attach drain hose to waste tee with 1
clamp*.
NOTES:
•
This connection must be located before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed.
•
It is recommended that the drain hose be looped up and securely
fastened to the underside of the counter at a minimum height of 32"
(81.3 cm).
a
e
d
*Parts available from local plumbing supply store.
SECURE DISHWASHER
To secure the dishwasher to either the Countertop (Method 1) or Cabinet
(Method 2), follow the instructions for the method specific to your
installation.
Method 1 - Installation to Countertop
Secure the dishwasher to the countertop using the two mounting clips
installed to the top of the dishwasher.
1.
Open the dishwasher, remove the lower dish rack, and place a towel
over the filters, located at the bottom of the tub, to prevent debris
from falling into the pump system.
2.
Check that the dishwasher is level and centered side to side in the
opening so there is no interference with adjacent cabinets when
opening or closing the door.
3.
Check that the tub flange aligns with the front face of the cabinet
frame.
1/2
" to 2" (3.8 to 5 cm) screw-type
a
Drain Hose -
Cut Here if
Needed
b
b
Screw-Type
Clamps
c
Drain Hose
d
Drain Trap
c
e
Waste Tee
32"
18"
Min.
Min.
31
Publicidad
