ASSEMBLY INSTRUCTIONS
3. Setting the cutting height
The product can be set to different cutting heights.
•
Use a 3/16 inch (5 mm) hex key (not included)
to loosen the nut on the side of the spindle
shaft.
•
Slide the trimmer head (F) upward or down-
ward to the desired position.
•
Retighten the nut.
4. Installing / removing the battery
4a. To install battery
•
Make sure that the batteries are fully charged.
•
Open the battery door.
•
Push the batteries into the battery compart-
ment. The batteries lock into position when
you hear a click.
•
Make sure that the batteries are installed
correctly.
•
Insert the safety key (I).
•
Close the battery door.
4b. To remove battery
•
Release the bail lever.
•
Remove the safety key (I).
•
Push the battery release buttons and pull out
the batteries.
3
4a
4b
13
F
I
I