Publicidad
Idiomas disponibles
Idiomas disponibles
Built-in installation drawings
For all types of built-in product, make sure, if your appliance is placed between two pieces of
furniture or in a corner against a wall, that the door opens sufficiently so that the shelves can be
taken out without any problem. In fact, on some models, the doors must be opened more than 90°
to pull out the shelves when removing a bottle.
Reversing the door
The instruction is based on a unit with right door hinge installed already. To reserve the door from right
hinge to left hinge, you need to get ready 2 new spare parts: an upper left hinge, and a bottom left hinge.
The hinge kit is included with your appliance. Check inside the product that you have these items.
You must have this kit to change the direction of the door.
All removed parts must be saved to do the door reinstallation, except those remarked with "disused".
1. Open the door, and loosen the 2 screws ① and ②. See Figure 1.
2. Carefully remove the door from the upper right hinge ④ and prevent it from scratching. Take out the
support rod ③ from the door hinge hole. See Figure 2.
3. Remove the 6 decorative plastic bolts covering located at the upper and lower left corners and keep
them.
4. Unscrew the upper right hinge ○,4(Disused) and bottom left hinge ○,6 (Disused) from the cabinet. See
Figure 3.
5. Install the upper left hinge ○,7and bottom left hinge○,8 to the left side of the cabinet. Make sure the
screws are tightened. See Figure 4. Use the replacement hinge kit included with your wine cabinet.
6. Put upside down the door and install it to the left hinges by following the opposite steps of taking down
of the door as described above
7. Cover the hinge screw holes, previously put aside, on the right side with the 6 decorating plastic bolts.
33
Publicidad
