Truper ASP-5X Instructivo página 20

Dry vacuuming
• Open the vacuum cleaner as shown on page 7 to verify
that the dry vacuum cartridge filter is properly installed.
• If not, place the filter in the filter cage (H) as shown in the
picture. Then put the motor cover in place.
WARNING • Do not vacuum or work near toxic,
flammable or explosive materials as indicated in the safety
warnings on page 5.
CAUTION • For dry vacuuming do not use the foam
filter for liquid vacuuming.
• After finishing the vacuuming job, empty the container
before storing the vacuum cleaner.
Wet vacuuming
• Open the vacuum cleaner as shown on page 6 to install
the foam filter for vacuuming liquids.
• Turn the motor cover upside down and place the filter in
the filter cage (H ) as shown in the picture. Then put the
1
motor cover in place.
• Do not vacuum or work near toxic,
WARNING
flammable or explosive materials as indicated in the safety
warnings on page 5.
CAUTION • Do not use the dry vacuum cartridge
filter for vacuuming liquids.
• When vacuuming large quantities of
CAUTION
liquids, do not immerse the nozzle completely in the
liquid; leave a gap at the tip of the nozzle opening to allow
air flow. The machine is designed with a float valve that
stops the suction action when the container reaches
maximum capacity. You will notice an increase in motor
speed. When this happens, turn the machine off, unplug
the power cord from the outlet, open the vacuum and
empty the liquid from the container into a receptacle or a
drain.
• At the end of the vacuuming job empty the container,
clean and dry the inside. Remove the foam filter and put
the cartridge filter in place before storing the vacuum
cleaner.
Blowing
WARNING • Read, understand and follow the
safety warnings on page 5.
• Make sure the container is empty before operating the
vacuum as a blower.
• Remove the hose from the vacuum port and connect it to
the blower port. If required, connect the extension tube(s).
• Hold the end of the hose or end tube firmly.
• Turn on the vacuum cleaner.
8
ENGLISH
Start Up
H
Turn the filter
cover clockwise
to secure the
filter in place.
Filter cap
To remove the
counterclockwi-
se to remove
H
1
filter, turn
the filter