SAFE 10/30 PLUS
BATTERY REPLACEMENT
If a warning tone (beep) is sent from the safe after each opening and closing, the batteries need to be
replaced.
To do this remove the protection cover by unscrewing the screw and replace the exhausted batteries with
new ones.
WARNING
Make sure that the batteries in question are alkaline 1.5 Volt. Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to the instructions.
WARNING
Batteries are delivered free of charge for the operating test and must be replaced in a short time.
EMERGENCY POWER SUPPLY
If batteries are not replaced before they are completely exhausted, it is possible to place a 9V battery in the
two contacts on the right of the display, to supply temporarily the Safe with power and therefore be able
to open it.
SAFE_10_30_PLUS_IM_20190506
Screw
Batteries
24
Two contacts for 9V
emergency battery
Receiver
Cover