Hendi 860502 Manual Del Usuario página 9

Descaling
This appliance should be cleaned and descaled frequently. To
keep this appliance in optimum condition and to ensure its op-
eration, it is crucial that you descale the appliance on a regular
basis. Depending on the hardness of the water and the frequen-
cy of use, you need to repeat the following procedure regularly.
To descale use a descaling agent that is suitable for the appli-
ance. You can also use pure lemon juice, citric acid or cleaning
vinegar as a descaling agent. To ensure the proper mixture,
read the instructions supplied with the agent. For pure lem-
on juice or cleaning vinegar the general mixture applies of 1/3
cleaning vinegar or lemon juice to 2/3 water.
1. Pour the solution in the boiler to maximum the"MAX" level.
2. Heat the solution by maximum temperature for 15mins.
3. Wait to allow the solution to loosen the build-up.
4. Rub lightly and gently with a brush with soft bristles.
5. Drain off the dirty water.
6. Repeat steps 1~5 until build-up has been removed.
7. Use a dry cloth to wipe the solution away.
8. When you drain off dirty water, leave the tap open and rinse
the boiler with clean water till taste and smell are completely
gone.
9. Now you can use the appliance again.
NOTE! Warranty is void if failure to descale regularly leads to
reduced functioning or failure of the appliance.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems Possible cause
Appliance does not No power at the
work socket
The plug is not
plugged (correctly)
into the power
point
Appliance does Heating element
not reach the set faulty
temperature
Control unit faulty
Heating element
fuse faulty
Buzzer alarms Heating element
overheat
Error codes identification
Error codes shown
on the display
E1
E2
E3
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
ranty, state where and when it was purchased and include proof
of purchase (e.g. receipt).
In line with our policy of continuous product development we
reserve the right to change the product, packaging and docu-
mentation specifications without notice.
Discarding & Environment
Possible solution
Check the fuse
Check the plug
rule may be penalized in accordance with applicable regula-
tions on waste disposal. The separate collection and recycling
of your waste equipment at the time of disposal will help con-
serve natural resources and ensure that it is recycled in a man-
Contact the
ner that protects human health and the environment.
supplier
For more information about where you can drop off your waste
for recycling, please contact your local waste collection compa-
ny. The manufacturers and importers do not take responsibility
for recycling, treatment and ecological disposal, either directly
or through a public system.
First, check if wa-
ter level is below
the "MIN" mark.
If alarm is still ON
after cool down,
contact the sup-
plier for aftersales
service
Possible cause
The temperature
of the appliance is
too high.
The thermo-pro-
tector is broken.
No power at the
electrical outlet.
The temperature
sensor is short-
ened or open.
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose
to your waste equipment by handing it over to a
designated collection point. Failure to follow this
GB
Possible solution
Clear all obstacles
that around the
appliance. Unplug
the appliance, wait
until the appliance
is completely cool
down.
Contact the
supplier
Contact the
supplier.
9