Publicidad
Idiomas disponibles
Idiomas disponibles
5 Turnupthe
volume
to a moderate
level with
the VOL control.
(_) MDR-RF960RK
Press the TUNE button
briefly for
automatic
tuning of the headphones.
If you do not receive a clear audio
signal, press it again.
VOL control
_) MDR-RF920RK
Tune the headphones
into the frequency
of the transmitter
with the TUNE
control until you can hear the audio
signal loud and clear.
Sending
RF signals
from
the Transmitter
The transmitter
starts sending
the RF signals
automatically,
when it detects
audio signals
from
the equipment
connected.
If it does not detect an audio
signal for more than
approximately
10 minutes,
the transmitter
will
stop sending
RF signals,
and the power
indicator
turns off.
When the transmitter
receives an audio signal
again, it starts sending
the RF signals, and the
power
indicator
will light in red again.
If the audio
signal is very weak,
the transmitter
does not send RF signals. If the transmitter
is
connected
to a headphone
jack, make sure the
volume
of the equipment
connected
is set to 5
6
or higher.
You may not hear the beginning
of the sound
from the headphones
until the transmitter
starts
sending
the RF signals after detecting
an audio
signal.
Note
[f the transmitter is connected to the headphones jack of
the source equipment, set the volume of theftequipment
as high as possible without distorting the audio signal
The headphones
automatically
turn
off when
they are taken off
- Auto power
on/off
function
Do not pull up the self-adjusting band when not
in use, as this will consume the battery power.
VOL control
Follow steps 3 and 5 above until the
receiving performance
becomes
better.
Bad
reception
conditions
[f you use the u_it near a cordless
telephone,
it may
cause radio interference.
[f poor reception
occurs,
try
another
channel
using the C HANNEL
selector.
Notes
• If hiss is hear, move c]oser to the tra]_smitter.
• You may heal; some noise when you disconnect
the
AC power adaptor
from the transmitter
before taking
off the headphones.
After
listening
to a program
Take
the headphones
off and
rest
them
away
on the
transmitter, and recharge them.
Note
Do not hang the headphones
by the self adjusting
band,
otherwise,
the self adjusting
band will be pulled
up and
the headphones
will be switched
on.
10cB
Publicidad
