Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: ALWAYS MAKE SURE THAT O-RINGS ARE SEATED PROPERLY INSIDE SUMPS BEFORE
TIGHTENING CANISTERS.
Model
1st Stage
2nd Stage
3rd Stage
4th Stage
5th Stage
Head Assebly
*Subject to change without notice
Sediment Filter (DB-10-05): This Pre-filter protects the system by reducing sediment from the water supply before
entering the Carbon Blocks and TFC membrane. The snow-white Sediment Filter should be changed when the
outside discolors but before the inner core discolors. The life of the Sediment Filter depends upon the condition of
the water supply and amount of water usage. Once your PROLINE EZ RO system is installed, check the Sediment
Filter at 3 month intervals until a filter life is established and then changed accordingly. The average life of a Sedi-
ment filter is 6 months.
Carbon Blocks (CTX-10-05): These Pre-filters protects the system by reducing chlorine, organic and inorganic
substance from the water supply before entering the TFC membrane. The average life of a Carbon Block
is 12 months.
TFC Membrane (MEM-PTRO1812-50): The high quality Thin Film Composite Membrane uses a separation process
that removes ions, molecules and large particles from the water supply leaving high quality product water for
consumption. This TFC Membrane should be changed when the product water has contamination levels, usually
measured in TDS (Total Dissolved Solids) higher level than desired. The average life of a TFC Membrane is 24 to
36 months. Although TFC membranes are designed for non chlorinated feed supply, your PROLINE® RO system
is equipped with double carbon pre-filtration for chlorine reduction prior to the TFC membrane.
Carbon Filter (IL-2010GAC-14F): This Post filter is designed to "polish" the product water by removing any remaining
taste and odor creating outstanding drinking water. This filter should be changed at least every 12 months or if
you experience an unusual taste or odor. The average life of a Post-Carbon is 12 months.
Head Assembly (sumps, housings, fittings, and valves) to be replaced every 7 years to ensure optimum operating
conditions and prevent consequential damage.
Drain your storage tank frequently to ensure the freshness of the water in the storage tank by lifting the faucet
handle into the open position until water flow stops from the tank. Return the faucet handle to the closed
position and the tank will refill in 2 hours.
Bladder Tank Pressure 7 to 8 psi without any water in the tank. To recalibrate all water must be drained from
the tank.
Replacement Components*:
Proline-350EZ
CTX-10-05
MEM-PTRO1812-50
CTX-10-05
-
-
SYS-PRO350EZ-HA
12
Proline-450EZ
DB-10 -0 5
CTX-10-05
MEM-PTRO1812-50
IL-2010GAC-14F
-
SYS-PRO450EZ-HA
Proline-550EZ
DB-10 -0 5
CTX-10-05
CTX-10-05
MEM-PTRO1812-50
IL-2010GAC-14F
SYS-PRO550EZ-HA
Publicidad
