Publicidad
Idiomas disponibles
Idiomas disponibles
A compression fitting may be found with the faucet. To make the connections,
slide a compression nut onto the tubing. Slip the white plastic sleeve onto the
tubing with the beveled end towards the end of the tubing. Insert a brass or plastic
insert into the tubing, bottom the tubing into the fitting, slide the nut up and
tighten with a wrench. DO NOT OVER TIGHTEN. Do not use the brass sleeves on
plastic tubing, use only plastic sleeves on plastic tubing.
* See page 2 for connection diagram on color coded tubing on systems with
STANDARD FAUCETS.
* See page 3 for connection diagram on color coded tubing on systems with
AIR GAP FAUCETS.
Sink
Never mount here
2) Mark the hole position on the pipe and drill a ¼'' hole through one
side of the pipe. Be careful not to drill the hole through both sides
of the pipe.
1) The head assembly will stand up in the sink cabinet or can be hung on screws.
2) The storage tank may be laid on its side. The bladder tank will function in both a horizontal or
vertical position.
3) The head assembly and/or storage tank may be placed up to 10 feet from the point of use
with some pressure loss.
COMPRESSION CONNECTIONS
DRAIN CLAMP INSTALLATION
1) The drain clamp assembly should be installed
Mount drain
saddle
at either location
3) Affix gasket provided with the drain clamp onto inside of clamp
piece matching the holes. The center hole on the gasket must
be removed.
4) Make sure to align drain saddle to drilled hole. Attach drain clamp
to drain pipe and tighten the two screws evenly.
5) Connect the 1/4" red tubing to the drain clamp (or 3/8" when air
gap faucet is used).
POSITIONING THE SYSTEM
above the trap and on the vertical or horizontal
tail piece
8
Connector
White Plastic Sleeve
Brass Insert
Compression nut
Plastic Tubing
Publicidad
