Amana Distinctions ARS2664AB Manual Del Propietário página 9

Temperature-Controlled Beverage Chiller T°
(Some models)
Temperature-Controlled Beverage Chiller" keeps
beverages up to 5°F (3°C) colder than refrigerator section.
Air inlet allows air from freezer section to pass to
Beverage Chiller
TM.
Air inlet is located on interior wall of
refrigerator door.
Beverage Chiller
TM
control is located on left front watt of
refrigerator section. Control adjusts amount of air
circulating in Beverage Chiller
TM.
Turn control to COLD for
normal refrigerator temperature and to COLDER for colder
temperature.
_A
A Beverage Chiller
TM
tempeIamre
control
B Turn control clockwise for
colder
Beverage Chillel
TM
flip top design
( Beverage (hilIei
TM
door
D All inlet
Beverage Chiller
TM
comes in a flip top and a roll top
design. It is adjustable to accommodate storage and
cleaning needs.
To remove Beverage Chiller
TM
perform the following
steps:
1. Grasp Beverage Chiller
TM
by sides lift up and pull out
to remove.
Note: If Beverage Chiller
TM
has a separate bottom
section, remove by pushing up and pulling out.
A Beverage Chiller
TM
bottom section
Beverage Chillei
TM
flip top design
To replace:
1. Slide Beverage Chiller
TM
bottom between desired shelf
rails in door liner and push down into place.
• If Beverage Chiller
TM
door track is cleaned, door
track must be lubricated with petroleum jelly for
proper operation of chiller door.
2. Slide Beverage Chi{ler
TM
between desired shelf rails in
door liner and push Beverage Chiller
TM
top down into
place over Beverage Chitter
TM
bottom.
ItvlPORTANT
For proper operation of Beverage Chiller
TM,
one of the
cold air intake holes must line up with notch in right door
dike.
A Door liner shelf rail C Flange
B Notch in dooi dike must line up D Beverage Chiller
TM
with one of Beverage Chiller
TM
E Beverage Chiller
TM
Door
cold aiI intake holes
Beverage Chiller
TM
rolI top and flip top designs
Remove Beverage Chiller
TM
cover (flip top model
only) by opening cover. Push cover inward at pivot
points and pull cover out. Replace cover by reversing
procedure.
A
c _
A Beverage Chiller
TM
top ( Beverage Chillei
TM
B Beverage Chiller
TM
cover bottom
Beverage Chiller
TM
flip top design
Door Buckets and Shelves
Graphic below does not represent all available bucket and
shelf designs, however the following instructions do apply to
all units.
Door buckets adjust to meet individual storage needs.
• Remove door buckets by pushing bucket up and
pulling out.
• Replace door buckets by sliding bucket in between
shelf rails and pushing door bucket down into place.
9