ENAR ZEN-C Manual De Operación página 49

5.6 STARTING THE MACHINE
Procedure
5.7 STOPPING THE MACHINE
Procedure
VIBRATORY PLATE
Perform the procedure below to start the engine.
1. Set the fuel valve to the open position (a1).
Note: If the engine is cold, move the choke lever to close position (b1). If the engine is hot,
set the choke to open position (b2).
2. Turn the engine start switch to the ON position (c1).
3. Move the throttle lever slightly to the left (d2), about 1/3 of the way toward the high
speed position (d1).
4. Pull the starter rope (e).
Note: If the oil level in the engine is low, the engine will not start. If this happens, add oil to
the engine. Your engine may be equipped with an oil alert light (f) that will illuminate while
pulling the starter rope.
5. Open the choke (b1) as the engine warms.
6. Set the throttle lever to the high speed position (d1) to operate the machine.
Perform the following procedure to stop the machine.
1. Set the throttle lever to the slow/idle position (d3) to reduce engine speed.
2. Turn engine start switch to the OFF position (c2).
3. Set the fuel valve to the closed position (a2).
en
ZEN-C 20 17