Publicidad
Idiomas disponibles
Idiomas disponibles
-
subject it to impacts or drop it onto hard surfaces
-
leave it exposed to direct sunlight
-
place obstacles between the remote control and the air conditioner while using it.
Furthermore:
-
if other devices operated by remote control (TV, radio, stereo systems, etc.) are located in the same room as the air conditioner,
there may be interference,
-
electronic and fluorescent lighting may interfere with communications between the remote control and the air conditioner,
-
remove the batteries in case of prolonged disuse of the remote control.
3.2.2
Fitting the batteries
The remote control exclusively requires 2 dry LR03 1.5 V batteries (not included with the supply).
Used batteries should be disposed of solely by depositing them into the appropriate collection points arranged by the Local Au-
thorities specifically for this type of waste.
Replace both batteries at the same time.
To insert the batteries remove the spring-latch cover on the back of the remote control.
The batteries have to be inserted according to the positive and negative pole markings in the bottom of the battery compartment.
Close the spring-latch cover after inserting the batteries.
3.3
REMOTE CONTROL
The remote control is the interface between the user and the air conditioner. It is therefore particularly important to familiarize
yourself with the parts of the remote control that relate to this interface.
All the references indicated in the following paragraphs refer to figure 29 on page 8 (unless otherwise specified).
3.3.1
Description of the remote control
Buttons (fig. 29): used to set or bring up machine functions.
T1
ON/OFF (standby).
T2
Well-being key (automatic)
T3
Night well-being mode.
T4
Operating mode selector.
T5
Fan speed selector.
T6
Button for setting timer and programs.
T7
Button for increasing (+) or decreasing (-) the temperature/time settings.
T8
Button for activating the FREE COOLING air change system (not available in this model).
T9
Movable baffle adjustment On/Off button.
T10
Reset button.
T11
Program start button.
Display (fig. 29): shows the operating state and the values of the settings being carried out.
D1
Fan speed or automatic operating mode indicator (AUTO).
D2
Heating.
D3
Cooling.
D4
Dehumidifier only.
D5
Air change activation (not available in this model).
D6
Night operation switch.
D7
Automatic operation switch.
D8
First operating program switch.
D9
Second operating program switch.
D10 Temperature indicator (thermometer) or time indicator (H/M).
The remote control is also equipped with a sliding cover that can be positioned so as to permit access only to the ON/OFF, Auto-
matic operating and NIGHT MODE buttons.
3.3.2
Main switch-on and running management
To manage the appliance with the remote control, it will be necessary to have activated the main switch which is included on the
electrical power supply line (the technician that installed the appliance could offer more details regarding the position), or insert
the power plug of the appliance into the socket of the system.
The machine is fitted with a power switch (fig. 28 ref. A) located below the lower safety guard (fig. 28 ref. B); to run it
must be in "I" position.
Once these operations have been carried out, the machine may be regulated using the remote control.
In order to transmit commands to the indoor unit, point the front of the remote control toward the unit's control panel.
The device emits a beep when it receives a command.
The maximum distance for transmission of commands is about 8 meters.
3
35
UNICO
Publicidad
