Publicidad
Idiomas disponibles
Idiomas disponibles
Unless otherwise specified, our "General Sales Terms" apply.
Warranty and liability claims in regards to persons or equipment damages are invalid, if one or
several of the following causes apply:
•
Improper use of the machine.
•
Improper assembly, startup, operation or maintenance of the machine.
•
Operation of the machine with defect safety devices or improperly fixed or non-functioning
safety and protection devices.
•
Non-observance of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine.
•
Independent structural alterations or settings on the machine beyond the intended purpose
•
Inadequate supervision of wear parts.
•
Improperly carried out repairs, inspections or maintenance
•
Catastrophic cases because of a war, acts of god or other reasons which are beyond our
control.
Disassembly
Disassembly and re-assembly should be done according to the sectional drawing only. Observe
the safety instructions of the operation and maintenance manual.
Disassembly of hose plate
Loosen hexagonal nuts item 4 and remove hexagonal screw item 3. Then pull hose plate item 1
out of the intake housing item 2 and discharge housing item 6.
Disassembly of impeller, assy.
Loosen hexagonal nuts item 12 and remove hexagonal screw item 11.
Then remove the intake housing item 2 from the discharge housing item 6.
The impeller, assy., item 24 is still on the shaft item 18.
Now loosen the hexagonal screw item 25 and remove the upstream hood item 27.
Loosen the socket head screws item 29 and pull the impeller, assy. Item 24, with a pull-off device
from the shaft item 18. Check the impeller item 24 with regards to damages.
Disassembly of bearing
Disassemble the hose plates item 1 and the impeller, assy., item 24.
Additionally loosen the hexagonal screws item 30 and remove the downstream hood item 32.
Loosen hexagonal screws item 23 and take bearing cover item 21 from the discharge housing
item 6.
Then loosen the hexagonal screws item 15 and remove the cover item 16.
The bearings item 17 and 20, the shaft item 18 and the spacer pipe item 19 are still on the
discharge housing item 6 and should be knocked out with an appropriate tool (e. g. a rubber
hammer).
WARRANTY AND LIABILITY
SPARE PARTS LIST
REPAIR
37
Publicidad
