Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6. Moving and placing the range
Air Sled Insert
NOTE
Adjust the leveling legs only as far as necessary to level the range. Extending the
leveling legs more than necessary or removing legs can cause the range to be
unstable.
Install_DOP36T86GLS_DG68-01106F-00_EN+MES+CFR.indb 23
Install_DOP36T86GLS_DG68-01106F-00_EN+MES+CFR.indb 23
1.
Due to the weight, heavy equipment
movers such as Air Sled should be used
to move this unit. The weight must be
supported uniformly across the bottom.
2.
After transporting the range by Air
Sled where you want, the range can
be leveled by adjusting the legs with
a wrench while Air Sled is supported.
Using a wrench, level the range by
turning the front leveling legs in or
out as necessary. Counterclockwise
shortens the leg and lowers the range.
Clockwise lengthens the leg and raises
the range.
3.
If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
4.
Position an oven rack in the center rack
position.
5.
Check the level of the range with a
carpenter level using the two positions
shown at right.
6.
After the range becomes level, Use Air
Sled to move the range away from the
wall so that the anti-tip bracket can be
installed.
7.
Step 7. Assemble the surface burners
CAUTION
Do not operate the surface burners without all burner parts in place.
Position surface burner heads on top of the surface burner manifolds as
1.
shown in the picture on the right. The electrodes will fit into the slot in the
bottom of the heads. Make sure the surface burner heads are flat and parallel
with the cooktop.
2.
Place the matching size caps on top of each surface burner head.
Top
After installing and leveling the range,
carefully remove Air Sled and install
front leg covers (right and left).
Bottom
English 23
2023-02-28 오전 10:32:47
2023-02-28 오전 10:32:47
Publicidad
