Publicidad
Idiomas disponibles
Idiomas disponibles
setting
and hammer-drill setting
torque levels + 1 screw setting + 1 drill setting + 1 ham-
mer-drill setting.
• Select a low level for small screws or soft materials.
• Select a high level for large screws, hard materials
or when unscrewing screws.
• For drilling work, select the drill setting by adjusting
the mode selection adjusting ring (4) into position .
• For hammer-drilling work, select the hammer-drill
setting by adjusting the mode selection adjusting
ring (4) into position .
Requirement:
Torque
Screws:
Level 1 - 19 Screw setting
Drilling:
-
Hammer-drilling:
-
8.8
On/Off switch (10) (Fig. 1)
The speed can be steplessly controlled by the on/off
switch. The further you press the on/off switch, the
higher the speed.
1. To switch on the product, push the on/off switch
(10).
2. To switch off, release the on/off switch (10).
If you put the direction of rotation switch (11) in the
centre position, the product is secured from being
switched on.
8.8.1
LED work lamp (9) (Fig. 1)
This product is equipped with an LED work lamp to illu-
minate the immediate work area and improve visibility
in poorly lit environments.
CAUTION
Do not look directly into the LED work lamp or the
light source.
1. The LED work lamp (9) lights up automatically as
soon as the product is switched on.
Note:
The LED work lamp remains lit up for approx. 10 sec-
onds after the product is switched off.
. There are 19
Operating mode:
Drill setting
Hammer-drill setting
www.scheppach.com
9
Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the
battery removed. There is a danger of inju-
ry! Let the Product cool down before all
maintenance and cleaning tasks. Elements
of the engine are hot. There is a danger of
injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
9.1
Cleaning
1. Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure. We recommend
that you clean the product directly after every use.
2. Ventilation openings must always be free.
3. Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interi-
or.
4. Wipe any dirt off the lens with a dry cloth. Be careful
to avoid scratching the LED lamp as this can se-
verely reduce the light intensity.
9.2
Maintenance
The product is maintenance-free.
10 Storage
Preparation for storage
1. Remove the battery.
2. Clean and check the product for damage.
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
GB | 25
Publicidad
