Publicidad
Idiomas disponibles
Idiomas disponibles
Door seal cleaning
Take care to
keep the
clean. Sticky food and drinks can
cause seals to stick to the cabinet
and tear when you open the door.
Wash seal with a mild detergent and
warm water. Rinse and dry it
thoroughly after cleaning.
Helpful Hints and Tips
Energy Saving Tips
We recommend that you follow the tips
below to save energy.
Avoid
keeping the door open for long
periods in order to conserve energy.
Ensure the appliance is away from any
sources of heat (direct sunlight, electric
oven or cooker etc.)
Don't set the temperature colder than
necessary.
Don't store warm food or evaporating
liquid in the appliance.
Place the appliance in a well
ventilated,
humidity freeroom. Please
refer to the
Installing your New
Appliance
chapter.
If the diagram shows the correct
combination for the drawers, crisper and
shelves, do not adjust the combination as
this is designed to be the most energy
efficient configuration.
door seals
CAUTION!
Only after the door seals are
completely dry should the
appliance be powered on.
Replacing the LED light
WARNING!
The LED light must be replaced by
a competent person. If the LED
light is damaged, follow the steps
below:
1. Unplug your appliance.
2. Remove the light cover by
lifting up and pulling out.
3. Hold the LED light with one hand
and pull it while pressing the
connector latch with the other
hand.
4. Replace the LED light and snap
it correctly in place and replace
the light cover.
Hints for fresh food refrigeration
Do not place hot food directly into the
refrigerator or freezer, the internal
temperature will increase resulting in the
compressor having to work harder and
consume more energy.
Do cover or wrap the food, particularly if it
has a strong flavor.
Place food properly so that air can
circulate freely around it.
15
Publicidad
