Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6".
0.4"~0.6"
Front roller
Adjustable
bottom feet
Door Removal
Tools you will need(Not provided)
1.With the door closed, remove the 3 screws
holding the top cover (A) with Philips (+)
screw driver, and then remove the top cover
with the entire-harness atached.
Rear roller
2.Remove the 3 screws (B) fixed on the hinges
with a wrench (5/16", 8mm) and 1 ground
screw (C) attached to the hinge with Philips (+)
screw driver. Remove the upper left and right
door hinges(D).
Adjustable
bottom feet
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator doors
and drawers. If you do not need to
remove the appliance doors, proceed
to 'Installing Water Lines' on page 8.
If you need to remove the doors,
continue below.
Allen Wrench (5/32",4mm)
Philips Screwdriver
：
Wrench (5/16",8mm)
6
Publicidad
