Proline VCBL700AA Manual De Instrucciones página 8

Wash the filter and cover under running water. Allow them to dry completely before replacing them
in the appliance.
Power Cord Rewinding
When not in use, unplug the appliance from the mains socket and then press the cord rewind
button to feed back the power cord.
CAUTION: Take special care to rewind the mains cord by holding the plug to avoid injury by a
whipping action.
Storage
The cleaner can be stored upright on its base. Insert the holder of the floor brush with tubes into the
storage clip at the rear of the appliance.
TROUBLESHOOTING
Please check the following details before you have your appliance repaired by an authorised
servicing agent.
Problem
Vacuum cleaner does
not work.
Suction power
becomes weak.
Power cord will not
fully feedback.
Power cord cannot be
pulled out.
SPECIFICATIONS
VCBL700AA
A
+++
A
++
A +
A
A
B
C
D
25.8
kWh/annum
C
78
AB DEFG
dB
C A
AB DEFG BCDEFG
665/2013 - II
Possible Cause
1. Check if the power plug is firmly
inserted into the power outlet.
2. Check if the power button of the
appliance is pressed.
1. Check if the hose, brush or tube
is clogged or damaged.
2. Check if the dust tank is full.
3. Check if the filter is clogged, the
tube is correctly attached.
Check if the power cord is twisted.
The power cord may be twisted.
Possible Solution
1. Insert the plug back into the
power outlet and ensure it is
switched on.
2. Press the power button to
turn on the vacuum cleaner.
1. Immediately remove the
obstruction.
2. Empty the dust tank.
3. Clean the filter or reassemble
the tubes.
Pull out the power cord at its
optimal length and rewind it.
Rewind or pull the cord in and
out several times by pressing the
cord rewind button.