Publicidad
Idiomas disponibles
Idiomas disponibles
plug connections from the wet.
- If there is a risk of flooding,
fix the plug connections in an
area that is safe from flooding.
• Ensure that the mains voltage
matches the specifications on the
rating plate.
• The electrical installation shall be
according to national wiring rules.
• Connect the equipment only to
a socket with a residual current
protection device (residual cur-
rent circuit breaker) with a rated
current of not more than 30 mA;
minimum fuse 10 amperes.
• Before each use, check the
equipment, cable and plug for
damage. Defective cables are
not to be repaired, but rather
replaced by new ones. Have
any damage to your equipment
repaired by a specialist.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the sock-
et by the cable. Protect the cable
from heat, oil and sharp edges.
• Do not carry or fix the equip-
ment by the cable.
• Use only extension cables that are
protected from spray water and
designed for outdoor use. Always
fully unroll a cable drum before
use. Check the cable for damage.
• Before any work on the equip-
ment, during work breaks and in
the case of non-use, remove the
plug from the socket.
• The cross-section of mains con-
nection lines must be no smaller
than rubber hose lines with the
designation H07RN-F. The pow-
er cable wire cross section must
be at least 2.5 mm
• Always disconnect the device
from the power supply before
assembling, disassembling or
cleaning it.
Initial Operation
Mount carrying handle
Fix the carrying handle (7) to the
garden pump using the fixing
screws (8).
Setting up
•
Place the unit on a firm, horizontal,
non-flooding surface.
•
If you would like to install the device,
screw it together with the base. A screw
connection with a fastening plate also
prevents the device from slipping.
By doing so, ensure a free access to
the drain screw (10).
•
Always put up the garden pump at a
point higher than the water surface
you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suction
hose (available from specialist retailers).
Mains Connection
The pump you have purchases is already
fitted with an earthed plug. The pump is in-
tended for connection to an earthed socket
at 230 V~ / 50 Hz.
GB
MT
2
19
Publicidad
