Publicidad
Idiomas disponibles
Idiomas disponibles
6
OPERATION
Do not operate near electrical power lines. The unit has not been designed to
protect from electric shock in the event of contact with overhead electric lines,
consult local regulations for safe distances from overhead electric power lines, and
ensure that the operating position is safe and secure before turning on the tool.
Always wear safety goggles or safety glasses with side shields during power tool
operation. Failure to do so could result in objects being thrown into your eyes and
other possible serious injuries.
Only use the attachments recommended by the manufacturer. The use of attach-
ments or accessories not recommended can result in serious personal injury.
Inspect the entire product for damaged, missing, or loose parts before each use.
Tighten all fasteners and do not operate this product until all missing or damaged
parts are replaced.
6.1 INSTALLING AND REMOVING THE BATTERY PACK
Always remove the battery pack from the product when you are assembling parts,
adjusting, cleaning, or when the blower is not in use. Removing the battery pack will
prevent accidental starting that could cause serious personal injury.
FULLY CHARGE THE BATTERY PACK BEFORE FIRST USE. Connect your battery pack to
the charger. Your battery should be fully charged before the first use of your product.
TO INSTALL THE BATTERY PACK:
1. Check to ensure that the trigger is not engaged.
2. Align the ribs of the battery pack with the mounting slots in the battery port. Insert the
battery pack into the battery holder. (Fig.5)
3. Ensure that the latch snaps into place and the battery feels secure.
Rib
Mounting slot
Fig.5
Page 14-English
GREEN MACHINE 62V CORDLESS POWERHEAD
TO REMOVE THE BATTERY PACK:
Put the tool on the ground before removing the battery pack. Injury could result if
the battery pack falls. Never remove the battery pack at a high location.
1. Turn off your tool.
2. Press the battery-release button to disengage the battery from the latch. (Fig.6)
3. Remove the battery from the power head.
Fig.6
6.2 TO START THE POWER HEAD
Avoid overworking or overusing your power tool. Use the tool as intended to avoid
damage to the machine or yourself.
Only switch the motor on when your hands and feet are away from moving parts.
Never operate the power head without an attachment.
NOTE: The attachment continues to move for a few seconds after the motor is switched off.
1. Stand upright and hold the product as designed. Place one hand on each handle.
Make sure the machine is not touching the ground or any other objects. (Fig.7A)
2. Press the lock-off button and hold it in that position, depress the trigger to turn on
the tool. Release the lock-off button and continue to squeeze the trigger for contin
ued operation (Fig.7B/7C)
Fig.7A
Fig.7B
GREEN MACHINE 62V CORDLESS POWERHEAD
Lock-off button
Fig.7C
Trigger
Page 15-English
Publicidad
