Publicidad
Idiomas disponibles
Idiomas disponibles
EHP System III
Presetting of clamping jaws:
N.B.: Turntable capacity can be changed before pedal
control.
The turntable jaws can be positioned in three diff erent
ways (Fig. 4.1-6).
Push the lever (C) on the left side of each jaw and shift at
the same each one (0/+2"/4").
1
2
VERY IMPORTANT: LOOK FOR PROPER INSERTION
OF THE PIN
CAUTION! MAKE SURE ALL FOUR CLAMPING JAWS
A
ARE MOUNTED IDENTICALLY (1 OR 2, FIG. 4.1-6).
B
OTHERWISE THE RIM MAY COME LOOSE AND
INJURE THE OPERATOR!
Rim diameters are shown in inches on the turntable (A,
Fig. 4.1-6). The diameter setting (mark on jaw (B) must
coincide with mark on turntable) depends on the clamping
jaw position 1 or 2.
· In jaws position 1 the diameter is preset directly
(1, Fig. 4.1-6).
· In jaws position 2 (2, Fig. 4.1-6) 4 inch must be
added to the diameter.
4.1-6
17
EN -
Publicidad
