Accessories; Maintenance Instructions; Daily Cleaning And Lubrication; Required Maintenance At Ridgid Authorized Service Center - RIDGID 320-E Manual Del Operador

320-E Press Tool

Accessories

WARNING
Ridge Tool Company provides jaw sets and ring sets
for use on various fitting systems. Use only RIDGID
jaw or ring sets which have been designed to press
the specific fitting system and tubing material you are
installing. For a complete listing of available RIDGID
jaw and ring sets, contact Ridge Tool Company or an
authorized RIDGID distributor. For tool accessories,
use only accessories listed below.
Catalog
No. Description
12683 14.4V Battery Pack (Original Equipment
Replacement Battery 2.6 Ah Ni-MH)
83407 14.4V Battery Pack (Optional 2.0 Ah Ni-Cd
Battery)
83417 115V Charger
84112 230V Charger
Fittings:
Refer to Fitting Systems operator's manual for a list of a-
vailable fittings for specific fitting systems.

Maintenance Instructions

WARNING
Make sure battery is removed from tool before per-
forming maintenance or making any adjustment.

Daily Cleaning and Lubrication

1. Wipe the tool with a clean dry cloth.
2. Inspect the jaw mounting pin and lubricate the pin with
silicone lubricant as needed.
Required Maintenance at RIDGID
Authorized Service Center
After 20,000 cycles, the tool will show a blinking yellow
LED on the display panel as long as the tool is turned on
to indicate that it is time for maintenance and recalibration.
The tool will not run if it is not maintained within 2,000
more cycles after the yellow blinking LED begins.
10

Storage

Place the tool and jaws in its carrying case. 320-E should
be stored above 23°F. (-5°C) and below 122°F (50°C).
The tool temperature sensor will not allow the tool to
turn on if oil temperature is not within this temperature
range. This will be indicated by a red blinking LED on the
display panel.
WARNING
locked area that is out of reach of children and people
unfamiliar with the 320-E Press Tool. The tool is danger-
ous in the hands of untrained users.

Service and Repair

Service and repair on this 320-E Press Tool must be
performed by a RIDGID Authorized Service Center.
The tool fasteners have been marked to indicate if
service has been performed by unauthorized indi-
viduals. Improper service or repair may lead to
extensive property damage, serious injury or death.
For any repairs or maintenance, contact the Ridge Tool
Company, Technical Service Department at (800) 519-
3456 or www.ridgid.com for nearest authorized service
outlet.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
Ridge Tool Company
Store the carrying case in a dry, secured,
WARNING