Uline Bostitch D62ADC Manual De Instrucciones página 2

• Use the Bostitch pneumatic stapler only for the
®
purpose for which it was designed.
• Never use this stapler in a manner that could cause
a fastener to be directed toward the user or others
in the work area.
• Do not use the stapler as a hammer.
• Always carry the stapler by the handle. Never carry
the stapler by the air hose.
• Do not alter or modify this stapler from the original
design or function without approval from Bostitch Inc.
STAPLER SPECIFICATIONS
ULINE PART NO.
H-3530
FASTENER SPECIFICATIONS
ULINE PART NO.
S-2724
S-2725
PARTS/STAPLE CHART
CLINCHERS
A01900601(L.H.)
SPACERS
STAPLE LENGTHS
DIAL POSITION
STAPLER AIR FITTING
This stapler must use a male free-flow connector plug,
1/4" N.P.T. The minimum inside diameter should be .300"
(8 mm). Fitting must be capable of discharging stapler
air pressure when disconnected from the air supply.
OPERATING PRESSURE
The operating pressure of the stapler is 70 to 100 psi
(5 to 7 kg/cm ). Select the operating pressure within this
2
range for best fastener performance.
CAUTION! Do not exceed the recommended
operating pressure.
PAGE 2 OF 18
SAFETY CONTINUED
MFG. PART NO. LENGTH
D62ADC 9" (228 mm)
LEG LENGTH STAPLE SERIES
5/8" (16 mm)
3/4" (19 mm)
Standard/Flat
A01900501(R.H.)
A02300801 A02300801
5/8" (16 mm) 3/4" (19 mm)
• Always be aware that misuse and improper
handling of this stapler can cause injury to yourself
and others.
• Never leave unattended with the air hose attached.
• Do not operate this stapler if it does not have a
legible warning label.
• Do not continue to use a stapler that leaks air or
does not function properly. Contact Uline Customer
Service at 1-800-295-5510 if your stapler continues
to experience functional problems.
SPECIFICATIONS
HEIGHT
8.625" (219 mm)
WIRE SIZE
.074 x 0.37"
SWC
(1.88 x 94 mm)
.074 x 0.37"
SWC
(1.88 x 94 mm)
D60065(R.H.)
175497
1/2" (13 mm)
AIR CONSUMPTION
Model H-3530 requires 4.0 cubic feet per minute
(.113 cubic meters) of free air to operate at the rate
of 100 fasteners per minute, at 80 psi (5.66 kg/cm
Take the actual rate at which the stapler will be run to
determine the amount of air required. For instance, if
your fastener usage averages 50 fasteners per minute,
you need 50% of the stapler's cfm of free air which is
required for running at 100 fasteners per minute.
WIDTH
4.5" (115 mm) 5.9 lbs. (2.5 kg)
CROWN WIDTH FASTENER RANGE
1⁄"
(35 mm)
1⁄"
(35 mm)
Shallow/Flat
D60066(L.H.)
175497
5/8" (16 mm)
ROLL
WEIGHT
CAPACITY
1,000
1/2" - 3/4"
(12-19 mm)
1/2" - 3/4"
(12-19 mm)
).
2
0424 IH-3530