VEVOR JX-DC-10 Manual De Instrucciones página 16

Step 8:
Connect the upper node with 1x bolt (part E), 1x nut (part K), 1x washer (part H).
The order of the poles must correspond to the order shown in the figure.
First put a washer over the bolt. Then insert the bolt from the inside through pole
1, then pole 2, then pole 3, then pole 4, then pole 5, then screw the nut onto the
bolt hand-tight.
Make sure that the poles are always aligned counterclockwise.
Step 9:
Now tighten all screw connections firmly with tools I and J.
Step 10:
Take 1x handle (part C) and 1x nut (part D).
Place the handle over the end of the screw on the framework. Fasten this with the
nut.
Note that the notch of the handle must be on pole 1 so that it is flush against all
rods (see illustration).
14