Numark Scratch Serato DJ Pro Guia Del Usuario página 7

20. Pad Mode Button: Press this button to cycle through the three pad modes: Cue, Sample,
and Roll. See
each mode.
21. Pad Mode Indicators: Displays which pad mode is selected. The LED corresponding to
the currently selected pad mode will be lit.
22. Shift: Use this button to access secondary controls of the Performance Pads and Loop
Knob.
23. Software FX Buttons: Press one of these buttons to select the corresponding software
effect (Echo, Delay, Flanger, Reverb, Version Echo, or Phaser). Once the effect is
selected with the Software FX button, it can then be applied to one or both decks with the
Effects Toggles.
The Software FX button LED will be dim when its corresponding effect is not selected. It
will be lit solid when its corresponding effect is selected, and it will flash when the effect is
activated with one or both Effects Toggles.
24. Effects Toggles: You can use these toggles to activate effects on a deck. When the
toggles are in the center position, all selected effects are deactivated.
To momentarily apply software effects to a deck, pull that deck's Effects Toggle down
and hold it in place. While you hold the toggle down, the effects will be activated. When
you let go of the toggle, it will automatically return to the center position, and the effects
will be deactivated.
To latch software effects on a deck, push that deck's Effects Toggle into the up position.
The toggle will lock into place, and the effects will be activated. To deactivate the effects,
pull the toggle back into the center position.
25. FX Mix: Controls the amount of effected (Wet) vs. non-effected (Dry) sound in the mix.
26. Loop Knob: Press this knob to activate an auto-loop on the corresponding deck. Turn the
knob left to decrease the length of the loop and right to increase the length of the loop.
Press the knob again to deactivate the loop.
Hold Shift while rotating this knob to scroll through lists of tracks, crates, etc. in Serato DJ
Pro. Hold Shift and press this knob to load the currently highlighted track to the
corresponding deck. Hold Shift and quickly double-press this knob to load the currently
highlighted track to both decks (creating "instant doubles").
Front Panel
1. Headphone Outputs (1/4", 1/8" / 6.35 mm, 3.5 mm, TRS): Connect your 1/4" or 1/8" (6.35
mm or 3.5 mm) headphones to this output for cueing and mix monitoring.
Operation > Pad Modes
1
to learn how to use the Performance Pads in
7