KSIX BXLAMP04 Manual Del Usuario página 3

4. Add your device
1. First, turn on the Bluetooth and WiFi of your phone.
2. Open the app and tap "Add Device" or "+" in the top right corner.
3. Select your smart device from the list of devices or use automatic scanning to find it
directly.
4. Turn on the device and wait until it flashes to confirm and select the type of flashing.
* If the device does not flash, restart it by following the steps detailed in the App: with the
device turned off, switch on, then switch off, switch on, switch off and switch on again and
the light will flash. In order for this process to work, it should be done in less than 10
seconds. Confirm and select the type of flashing.
5. Next, select the 2.4 GHz WiFi network, enter the router password and wait while the app
finds the device. Once it has been added, tap "Finished".
Note
1. To ensure a correct synchronization with your mobile phone, it is necessary to accept all
the accesses requested by the app.
2. To connect for the first time, you must be connected to a Wifi network. Make sure that the
light is flashing quickly and that the WiFi password you entered is correct. (The
connection process may take several minutes, please be patient).
3. After the first connection, you can use a new WiFi or mobile data network to control the
device at any time and from any location.
4. Only compatible with 2.4 GHZ WLAN, Android 4.1 and above and IOS 8.1 and above. Do
not use 5G WiFi.
5. The first connection should be made close to the router to ensure a faster connection.
6. When connecting multiple devices to the WiFi network, do not put them too close
together as this may cause signal interference.