cecotec HYDROBOOST 10000 LIBERTY Manual De Instrucciones página 19

ENGLISH
Indicator status
Red light is always on
Green light is always on
Flashing red light
3. PRODUCT ASSEMBLY
Step
Removing the battery.
Charging the battery. Check the charging instructions for further details.
Battery indicator
Installing the battery.
Installation
Installing the multi-function nozzle
Note: When the nozzle is installed, shake the nozzle gently to check if it's
correctly installed.
Connecting the water inlet's hose
Note: When the hose is installed, shake the nozzle gently to check if it's
correctly installed.
Operation
Select the operating mode.
The device can operate under two modes: High mode, which is used for
cleaning the most stubborn dirt, and the Energy-saving mode (ECO), to
clean the easier dirt.
Operation
Note: The air inside the hose must be drained every time the device is
used. Hold the device below the waist (<1.5 m) and select the high pressure
mode. The water will be suctioned with the hose and will be ejected. This
process takes about 15 seconds.
Select the water-spray effect
The water-spray effect (multi-angle nozzle) must be selected according to
the working conditions. The 0º, 15º and 40º modes are suitable for cleaning
and watering.
Do not use turbid, muddy or corrosive water.
36
HYDROBOOST 10000 LIBERTY HYDROBOOST 10000 LIBERTY
Status description
Charging
Finished charging
Battery failure
Figure
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Warning
Other
The device can also be used with other accessories.
Assemble the detergent bottle to remove by spraying on the most
stubborn dirt. Adjust the detergent-spray rate by turning the knob.
Use only soap for pressure washers.
The proportion of water and soap should be: 5,4 % of soap and 94.6 % of
water, 1:19 approximately.
Try the soap where it will not be too visible before using the device.
Open the bottle for soap and fill it with water and soap.
Cover it again.
Remove the lance.
Install the bottle for soap in the spray gun.
Let the soap act on the surface for some minutes. In the meantime, scrub
the dirtiest zones with a brush. Do not let the soap touch the surface.
Remove the bottle for soap from the spray gun and replace it for the lance.
You can also remove it from the tip of the lance.
Clean the soap from the surface.
Note: Wash the bottle for soap with water after each use.
Final rinse
Start the final rinse from the bottom to the top. Make sure the surface is
correctly rinsed and that the dirt has completely been removed.
Assemble a long nozzle (lance) to clean the dirt on the ground or in walls.
Adjust the fan's spray angle by rotating the tip.
Cleaning the inlet's connector.
Cleaning the inlet filter.
4. OPERATION
Adjusting water stream
The angle of the water stream coming out of the nozzle can be adjusted with the pulverising
nozzle by rotating the tip. This will vary the water pattern from approximately a 0° narrow
high-impact stream to a 60° wide fan spray.
Fig. 20
This appliance offers 2 modes:
Focused mode
ENGLISH
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
37
HYDROBOOST 10000 LIBERTY HYDROBOOST 10000 LIBERTY