Electrex TP 254 Manual De Instrucciones página 12

MMA welding
Item Letters
1 HS
tHS
1
IP
2
3 AF
Pulsed MMA welding – the welding current oscillates between a high and a low current value allowing less
thermal input in thinner plates and greater arc control in the most demanding positions (vertical ascending).
Item Letters
IB
4
5 UTH
Fre
6
- Adjust the current value to the diameter of the electrode (Fig.2 - 2), according to the following table, to
adjust the machines according to the electrode to be used and start welding
Electrode diameter (mm)
Adjusting current scope (Amp)
- Start welding.
(See items in Fig. 2)
Parameter
Hot Start Percentage increase in current value in relation to Ip (main
current), applied at ignition and start of welding.
Time Hot Time elapsed since the start of welding in which the "Hot Start"
Start value must be valid.
I / I Adjust the main current value.
2 p
Arc Force To prevent the electrode from sticking to the workpiece during
welding, vary the Arc Force current amplitude in relation to the
main current. For values with a (-) sign, the Arc Force transition will
be rougher. For values with a (+) sign, the Arc Force transition will
be smoother.
Parameter
I Adjust welding base current in percentage of main current.
b
WIDTH Adjust width of the peak current (main)
PULSE Adjust the pulse frequency.
FREQUENCY
Æ 2,0
50 - 70
Description
Description
Æ 2,5 Æ 3,2 Æ 4,0
60 - 100 80 - 150 130 - 200
Æ 5,0 Æ 6,0
150 - 260 200 - 360
12