Electrex TP 254 Manual De Instrucciones página 9

4. CONTROL PANEL
No.
1 Welding mode selector: TIG HF (TIG welding with high frequency ignition), LIFTIG (TIG welding with
contact ignition), MMA welding, PULSE (when lit with another mode also lit, indicates pulsed welding with
the respective welding mode)
2 Power ON indicator
3 Overheating indicator – When switched on, the entire welding service and the interface will be blocked
4 Error indicator. See error description in this instruction manual
5 When switched on, there is a communication with an external device
6 2T/4T and SPOT (tack welding) selector
7 Cooling detection in TIG - Not active
8 Cooling detection in TIG - Active
9 Welding current display
10 Welding voltage display
11 Welding programs / welding current key button – when pressed allows welding programs selection or
shows welding current on the display
12 Parameters adjusting and selecting – Pressing allows you to select parameters. Turning allows you to set
the parameter value
13 Welding parameters – see description of this parameters on this user's guide in "7. FUNCTIONS"
Fig. 1
Description
9