Service And Maintenance - Drive AQUAJOY PREMIER PLUS Instrucciones De Funcionamiento

REV.9
Empty the water from the bath.
Pressing the "down" button on the hand control, take the bathlift to its lowest
position in the bath, continue to press the down button until the backrest reaches
its' fully reclined position.
Take hold of the two side flaps and fold them inward onto the seat.
Take hold of the backrest, pushing it forward so that it lies flat onto the seat.
REMOVING YOUR BATHLIFT
With the backrest folded forward onto the bathlift seat, simply detach the backrest
from the base by lifting it upwards (as above). The backrest grooves will detach
from the seat (base) grooves.
To remove the seat (base), simply place one hand on the lifting bar at the rear of
the base and lift to release the bathlift from the bath. Continue to lift and the
suction feet at the front of the bathlift will release automatically. Place your other
hand on the front of the bathlift and lift.
Continue to lift your bathlift base out of the bath and you can now store your bathlift
away.

SERVICE AND MAINTENANCE

The AQUAJOY PREMIER PLUS BATHLIFT requires minimal maintenance
/servicing. Please check that everything is in good working order at regular
intervals (at least once every month). The Bathlift actuator is tested to last 10,000
cycles if used and maintained correctly in the environment for which it has been
designed. However, in order to maximise the life of the Bathlift and to ensure
optimum reliability, performance and safety, AquaJoy Bathlifts Ltd recommends
10