Drive AQUAJOY PREMIER PLUS Instrucciones De Funcionamiento página 7

REV.9
Image 1 : Alignment Direction
Image 3: Fully Engaged
INSTALLING YOUR BATHLIFT
• Please ensure your bath tub is clean and dry before installing your bathlift.
• Simply remove the bathlift parts separately from the box (remove backrest
first and then the seat (base).
• Place the seat (base) onto the flat part of the bath. Please ensure that there
is sufficient space for the bathlift to fully
that your Bathlift suction feet are securely sticking to the bottom of your
bath. If you have dimples or ripples on your bath, you may need to
purchase additional middle suction feet to ensure safe and secure adhesion
to the bath. Please check that your suction feet are sticking to the bottom of
your bath every time before you have a bath.
• Take the backrest and simply place it flat on top of the seat, matching the
grooves on the backrest to the grooves on the seat (See earlier point).
• Simply lift the backrest up until it is in the fully reclined position.
PLEASE NOTE: BEFORE YOU FIRST USE YOUR AQUAJOY PREMIER PLUS /
JUNIOR PLUS BATHLIFT, PLEASE CHARGE YOUR BATTERY HAND
CONTROL FOR TWELVE HOURS. AFTER YOUR FIRST USE, PLEASE
CONTINUE TO CHARGE YOUR BATTERY HAND CONTROL AFTER EVERY
BATH. YOU CANNOT OVERCHARGE YOUR BATTERY HAND CONTROL. IF
THE HAND CONTROL INDICATOR LIGHT FLASHES RED IT MEANS YOU DO
NOT HAVE SUFFICIENT CHARGE TO USE YOUR BATHLIFT. PLEASE
RECHARGE IMMEDIATELY. THE HANDCONTROL INDICATOR LIGHT WILL
Image 2 : Closer look
Image 4 : Lift up front centre
recline. CAUTION:
7
Please ensure