TECE SH-HCM Guía De Usuario página 17

GB
Device 1: SH-HCM
Set the device to RF coupling mode.
Press the button for 10 seconds.
6. Trouble Shooting
Symptom
Red/Blue blinking on
Heat and Cool and RF
LED
Red blinking on Pump/
Humidity LED
7. Technical characteristics
7.1 Technical Data
Electrical protection
IP Protection
Shipping and storage temperature
Power supply
Output maximum load (5 outputs)
Compatibility
Device 2: SH-CD6-230
By pressing
troller goes in RF pairing menu.
By using
blinks red), press
with a slave device mode.
All LEDs are blinking green.
Trouble
RF Issue
NTC error
SH-HCM
Class II with functional earth
IP30
-10 °C à 50 °C (14 °F à 122 °F)
230 Vac ± 10% 50 Hz
Relay: 5 A
SH-CD6-24, SH-CD10-24, SH-CD6-230, SH-CD10-230
for 5 seconds, the con-
or select zone 3 (LED
to enter in Pairing
Description
The SH-HCM has lost
the connection with the
SH-CD controller.
If DIP4 = ON, a water
temperature sensor
should be connected on
Humidity input.
Remarks
When link is done, SH-CD returns to
the RF pairing menu and SH-HCM
returns to normal mode.
Trouble shooting
Check distance between devices. If
the device is installed within a metallic
box, use an external antenna located
outside the metallic box. External
antenna is also useful for a long dis-
tance between devices.
Usage of an external antenna on the
SH-CD and SH-HCM improves the RF
communication.
Usage of a repeater paired to the
SH-CD may be required.
Check DIP4 setting and NTC.
17