Descargar Imprimir esta página

GE WSLP1500 Manual Del Propietario E Instalación página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
. IMPORTANT - Save these
instructions
for local inspector's use.
" IMPORTANT
-
Observe all governing
codes and ordinances.
. Note to Installer
- Be sure to leave these
instructions with the Consumer.
. Note to Consumer
- Keep
these instructions
for future reference.
. Skill level - Installation of this appliance requires
basic mechanical skills.
. Completion
time-
1 hour
. Proper installation
is the responsibility
ofthe
installer.
Product failure due to improper installation is not
covered under the Warranty.
Note
- This appliance must be properly grounded,
and electrical service to the washer must conform
with local codes and ordinances and the latest
edition of the National Electrical Code, ANSI/NFPA70.
WASHER LOCATION
Washer must be installed on firm flooring to minimize
vibration during spin cycles. Concrete flooring is best,
but wood base is sufficient providing floor support
meets FHA standards. Washer should not be installed
on rugs or exposed to the weather.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the
weather.
ELECTRICAL
This appliance must be supplied with the voltage and
frequency indicated on the rating plate (located on
the back of the washer) and connected to an
individual, properly grounded branch circuit, protected
by a 15- or 20-amp circuit breaker or time-delay fuse.
PLUMBING
WATER PRESSURE--Mustbe 10 p.s.i, minimum to
150 p.s.i, maximum dynamic pressure measured at
faucet.
WATERTEMPERATURE--Household water
heater should be set to deliver water at 120 ° to
!50°F (50° to 66°C) IN THEWASHERwhen HOT wash
is selected.
SHUT-OFF VALVES--Both
hot and cold shut-off
valves (faucets) should be supplied.
DRAIN--Water
may be drained into a standpipe
or
set tub. The discharge
height MUST NOT BE LESS
THAN 30" nor more than 8' above the base of the
washer. The standpipe
must be !½" minimum
inside
diameter
and must be open to the atmosphere.
RACK INSTALLATION
. Ensure washer is centered between the rack sides.
PARTS SUPPLIED
Drain Hose
Water Hoses (2)
TOOLS REQUIRED
Pliers
13

Publicidad

loading

Este manual también es adecuado para:

Wsls1500