Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Keep the product, battery, and battery charger out of
the reach of children and unauthorized persons.
Save these instructions
3
ASSEMBLY
This section describes how to assemble and adjust the
product.
DO NOT USE PARTS OR ACCESSORIES
THAT ARE NOT RECOMMENDED BY THE
MANUFACTURER.
ENSURE THAT ALL PARTS ARE PROPERLY
ASSEMBLED BEFORE INSERTING THE
BATTERY.
READ AND UNDERSTAND THE SAFETY
CHAPTER AND THE ASSEMBLY INSTRUCTIONS
BEFORE YOU ASSEMBLE THE PRODUCT.
3.1
INSTALL THE UPPER HANDLE
1.
Remove the rubber edge guard on top of the
lower handle and discard it.
2.
Next, remove the protective plastic film from
the lower handlebars. Remove the EPE foam
wrapped around the power cord.
3.
Position the mower in a vertical position,as shown
in the diagram below, to install the upper handle.
The upper handle should be at the top of the
handle shafts, handing by a black control cable.
WARNING
WARNING
WARNING
English
4.
Carefully guide the control cable through the
shafts while inserting the upper handle into the
lower handle.
5.
Insert the bolts through the holes and tighten
the nuts using a Philips-head screwdriver (not
included) to secure the handle in place.
*You can find bolts in the plastic bag hanging on
the handlebar latch.
BE CAREFUL NOT TO PINCH, CRIMP, OR
DAMAGE THE CONTROL CABLE WHEN
INSTALLING THE HANDLE.
8
WARNING
Publicidad
