bloom luxo sleep Guia Del Usuario página 10

eng
side of base board.
– Lock the clasps on both ends of the base
board, check the clasps are firmly locked and
the base board should be both secure and
perfectly flat.
– Side A has one single plastic guiding rail that
runs down the each end panel's edge. See
illustration 4. Fixed side panel fits onto side A.
– (#04 fixed side panel) Slide the fixed side
panel onto the guiding rails located on side
A of the end panels. NOTE: The side with the
mattress level limit mark
of the baby bed. Slowly lower the panel all
the way down until locked into position, you
will hear an audible click. Ensure panel is
secure by pulling it upwards gently.
– The bed assembly is now complete.
Optional bed rail is available as accessory.
Please check with your retailer or
bloombaby.com for more details.
10 - 13 Storage
– Remove the drop side panel by squeezing the
two triggers on the either sides of the drop
side simultaneously, and slowly slide panel
upwards all the way
– Remove the fixed side panel by sliding the
trigger located under the bottom right corner
of the panel, while sliding panel upwards all
the way.
– Remove mattress and base board from frame
– unlock the clasps on both ends of the base
board by sliding buttons inward and lift the
base board out.
10
faces to the inside
– Fold bottom side rails inwards and push end
panels in together. Make sure the panels are
folded in the correct direction.
Mattress
– Mattress is not included with the baby bed.
This can be purchased separately. Always
use a mattress with your baby bed.
– Minimum size of mattress to be used with
the baby bed should be 135 cm /
53 inches x 70 cm / 27½ inches, and the gap
between the mattress and the sides and ends
must not exceed 30mm.
– Mattress thickness shall not exceed the level
limit mark indicated on the inner facing of
the side panel for both base board heights.
Thickness of the mattress shall be such that
the internal height (surface of the mattress to
the upper edge of the cot frame) is at least
500 mm / 19¾ inches.
– Using the wrong size mattress may create
hazardous gaps that could result in
suffocation or could reduce the side height of
the cot which may result in your child falling
out from the cot.
WARNING:
• WARNING: Be aware of the risk of open
fire and other sources of strong heat, such
as electric bar fires, gas fires, etc. in the
near vicinity of the cot.
• WARNING: Do not use the cot if any part
is broken, torn or missing and use only
spare parts approved by the manufacturer.