Removing The Robot From The Swimming Pool; Manual Stop Control - Maytronics WAVE 300 XL Instrucciones De Uso

4
CrissCross
lock
figure 4: Countdown screen for 4 hour session
The countdown screen shows that a 4 hour cycle time was selected and that the time remaining is
3 hours, 59 minutes and 59 seconds.
At the end of the cleaning session, the robot stops automatically.
To remove the robot from the pool, proceed as explained in removing the robot from
Swimming Pool on page 6.
To avoid unauthorized changes to the MMI settings you can lock the MMI's keyboard:
TIP
From the Countdown screen, press Lock (Figure 4).
To unlock the keyboard, press POOL and then HOME in that order.

7. removinG THe roboT from THe SWimminG PooL

1. Press Home.
The robot starts moving in the direction of the floating cable.
2. Holding the floating cable, gently pull the robot upwards and towards the Caddy. As it reaches the
side of the pool, pull the cable gently until the floating cable handle emerges. Grasp the handle
and pull the robot out of the water. The robot shuts down automatically. By using the remote
control you can drive the robot to the Caddy.

manual stop control

If necessary, you can stop the robot during the
cleaning session.
1. From the Countdown screen (Figure 4),
press Stop. The MMI screen displays the
message: "Stopping robot – please wait".
After 5 seconds the Manual Stop screen is
displayed (Figure 5).
2. To stop the cleaning session completely,
press exit. The MMI display returns to the
Wave screen.
6
hh:mm:s
- cycle
hr
03:59:59
stop
5. Using the arrows   select the required
pool length. Press Set.
For ft. measure units continue scrolling to the
right using  arrow.
6. Press Start. The cleaning session will begin.
The factory default settings are used. In order
to change parameters refer to Configuring
Additional Pool Profiles on page 9.
The robot starts its cleaning cycle and
the MMI displays the Countdown screen
(Figure-4):
Manual Stop
Completed Time
Total Hours
Filter Bag
figure 5: manual Stop screen
Wave XL
01:20
Clean
exit
User Instructions
|