Remote control instructions
● When moving, never switch between forward and backward – this can damage
the gearbox and motor.
● The remote control requires a battery.
● Only and adult should use the remote control.
● This product is mainly operated by the remote control.
Instructions:
● Hold down the 'Forward' and 'Back' button for three
seconds to start – The LED light will flicker.
● Turn on the power for the car – the LED will light up.
● Press 'S' to choose your speed. When one LED is lit, the
product will operate at low speed, two lit LEDs is
medium speed and three lit LEDs is high speed.
● Press 'P' to break – all LEDs will flicker.
● If no button is pressed after 10 seconds, the remote will
enter standby. Press any button to start using again.
● Never mix new, old or different types of batteries together.
● Never mistake positive and negative electrodes of a battery – this could lead to a
short circuit.
● Do not charge non-rechargeable batteries.
● Place batteries into the right polarity.
● Only adults should charge and change batteries.
● Take batteries out of the product when charging.
● Take dead batteries out of the product – keep out the reach of children.
● Use a screwdriver to remove the battery screws, open the cap as the arrow signals,
then insert two AAA 1.5V batteries.
- Remove the nut and gasket from the front axle.
- Install the wheel, gasket and nut onto the front axle – tighten the nut with a wrench.
- Install the cover onto the wheel.
- Repeat for the wheel on the other side.
Battery specifications
1. Installing front wheels
4
Right