Getting Started; Operations - Bissell PET HAIR ERASER 1941 Serie Guía De Inicio Rápido/Usuario

Tool Caddy Options

Getting Started

WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating
procedures.
NOTE: Be sure the green suction knob on side of vacuum is turned to
"Floor Suction" before use.
1
Step gently on base and pull back on
handle to recline.
Turn Height
3
Adjustment Knob
to desired carpet
cleaning level.
6
www.BISSELL.com
Store both the Flexible Crevice Tool
and the Pet TurboEraser Tool. Push
hard on the double tool caddy to
slide it on the base of the vacuum.
DOUBLE
TOOL CADDY
2
Power
On/O
Switch
Turn vacuum on by pressing Power Switch on
(I - ON and O - OFF). Press Brush roll switch to
run the PowerBrush for carpet cleaning (brush
roll is on when light on switch is illuminated).
NOTE: The brush roll will automatically shut off
when vacuum is locked in upright position,
recline to reactivate.
NOTE: For optimal carpet cleaning
performance, adjust to the lowest
practical setting. If your vacuum is difficult
to push, adjust to the next higher setting.
NOTE:
In the unlikely event that hair
wrapped around your brush roll, run vacuum
back and forth on clean carpet several times.
This will help release any wrapped hair.
Brushroll
On/O
Switch