Descargar Imprimir esta página

REV Ritter L19550S Instrucciones De Montaje Y Utilización página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

SAFETY INSTRUCTIONS FOR BATTERIES
• Do not attempt to revive batteries or rechargeable batteries by heating or similar measures. Primary batteries
must not be recharged as this can lead to electrolyte leakage, explosion or fire.
• Do not immerse batteries in water and store them in a dry, cool place, not a damp one.
• Do not throw batteries into a fire, do not open them nor solder or weld them yourself.
• Do not short-circuit batteries.
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• USB charging cable
TECHNICAL DATA
• This product contains light sources of energy efficiency class F
• Output: 2x10W LED
• Illuminant: SMD LED´s
• Luminous flux: 2x900lm
• Colour temperature: 6500K
• Colour rendering index (Ra/CRI): ≥ 80
• LED service life: 30.000h
• Beam angle: 80°
• IP protection class: IP20
• Protection class: III (S5)
• Ambient temperature: 0°C – 50°C
• Dimensions W x H x D: folded: 297 x 210 x 80mm; folded out: 297 x 297 x 70mm
• Weight: 1710g
• Battery: 3.7V / 8000mAh / lithium polymer battery (126090) / 29,6Wh
• USB: Micro IN 5VDC, max. 2A; USB OUT 5VDC, max. 2A
OPERATION
• Charging: Before (first) use, fully charge the product until the charge indicator light turns green
• The product has a charging input with a Micro-B type socket. Only use the enclosed USB charging cable, which
can be plugged into a conventional USB power supply unit (socket: type A). Only use tested USB power supply
units with a maximum output voltage of 5V.
• Connect the USB charging cable to the charging input on the product and the USB power supply unit (A2).
• Charging time: 6 hours (depending on the selected USB power supply)
• Duration: 3 hours (1700lm) / 5 hours (900lm)
• 1x press: one side (900lm)
• 2x press: opposite side (900lm)
• 3x press: both sides (1700lm)
• 4x press: OFF
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
GB
10

Publicidad

loading

Este manual también es adecuado para:

Flex power 202620011710