Blastrac BDC3140 DBP Manual De Instrucciones página 21

Operating manual BDC3140 DBP/LPP
Dimensions
Figure 3
Model
230/60
A (mm)
B (mm)
C (mm)
Weight (kg) 211
Model
230/60
A (mm)
B (mm)
C (mm)
Weight (kg) 215
[ NOTE ]
Storage conditions:
■
Temperature: -10°C ÷ +40°C
Humidity: ≤ 85%
■ Operating conditions:
Maximum altitude: 800 m
(Up to 2,000 m with reduced performances)
Temperature: -10°C ÷ +40°C
Humidity: ≤ 85%
Controls, indicators and connections
Figure 4
Dust container release lever
1.
Castor lever
2.
3. Main switch
Start button
4.
Stop button
5.
6. Voltage presence white indicator
Thermal protection operation red indicator
7.
Compressor start/stop button (440V/60Hz - 230V/60Hz)
8.
9. Compressor pressure governor (440V/60Hz -
230V/60Hz)
Compressor start/stop button (400V/50Hz)
10.
11. Compressor pressure governor (400V/50Hz)
BDC3140 DBP
400/50 440/60
1600
1200
600
196 234
BDC3140 LPP
400/50 440/60
1600
1200
600
200 238
Inspections prior to starting
Figure 5
1. Inlet
Prior to starting, check that:
The filter is installed.
■
■ All latches are tightly locked;
The vacuum hose and tools have been correctly fitted
■
into the inlet (1);
■ The bag or safety container is installed, if applicable.
Do not use the device if the filter is faulty.
Starting up
Figure 6
Castor brakes
1.
Lock the castor brakes before starting the vacuum cleaner (1).
Starting/stopping the vacuum cleaner
Turn the switch (3) (figure 4) to "I" position to
■
electrically power the vacuum cleaner. The voltage
presence indicator (6) (figure 4) comes on.
Push the start button (4) (figure 4) to start the vacuum
■
cleaner.
■ Push the stop button (5) (figure 4) to stop the vacuum
cleaner.
Turn the switch (3) (figure 4) to "0" position to turn off
■
the electrical power of the vacuum cleaner.
WARNING!
The start/stop button (8 and 10) (figure 4) of the
compressor should always be in "I" position during
the operation.
WARNING!
Check the pressure of the air used to clean the
filters which is produced by the compressor.
It must never be superior than 5,5 bars, if
necessary, adjust it to the correct level using the
related pressure governors (9 e 11) (figure 4).
WARNING!
The activation of the indicator (7) (figure 4) signals
the operation of the vacuum unit thermal protection
due to the excessive electrical power draw of the
unit.
7/12
info@blastrac.eu
GB