Donner HUSH-I PRO Manual De Usuario página 6

ASSEMBLE THE STAND
This stand is not assembled to the guitar body when shipping from the
manufacturer Before using the instrument, please correctly assemble the
stand using the procedure described below.
1. Make sure the direction of the stand is aligned with the guitar body.
Put the end of the rod fully inserted into the corresponding bracket,
then release it.
2. First, insert the rod of the lower stand ① (the shorter one) fully into
the bracket hole on the guitar's main body. Next, insert the lower rod
of the upper stand ③ (the longer one) fully into the bracket hole, and
the upper rod ② fully into the bracket hole.
● Make sure that the upper rod② and lower rod③ of the stand are
not reversed.
● Make sure not to press down the rod firmly or it may be damaged.
Reverse the procedures of the above steps if you need to
disassemble the stands.
● Make sure to check whether the rods are fully inserted prior to use.
The instrument may drop during the performance when the rods are
not fully inserted completely.
● Please hold the guitar neck or guitar body when you carry the
instrument. Holding only the left stand or right stand will result in
damage to the stands and fixed parts.
GUITAR NECK ADJUSTMENT
1. The location of the truss rod.
2. Neck relief checking and adjust methods:
Step 1: Make adjustments gradually. The guitar neck should normally be
slightly concave and check the curvature after each 1/2 turn of the truss rod
nut.
Step 2: Check the curvature of the neck. Holding the guitar with a playing
posture after fine-tuning. Then press the first string on the first and the last
fret and measure the height between the string and fret at the 8th fret. In
the same way, measure this height for the lowest string, and make
adjustments so that the heights are in the range of 0.1-0.2mm.
Step 3: Turning the nut clockwise can make the neck bulge, which can
correct the problem that the neck is too concave, and the string action is too
high. Turning the nut counterclockwise can make the neck concave, which
can correct the problem of buzzing caused by excessive neck convex.
Rod End
③
If the neck is
excessively
convex
3
②
0.1-0.2mm
8th Feet
If the neck is
concave
excessively
concave
convex
①