Donner HUSH-I PRO Manual De Usuario página 9

2. Follow the principle that after connecting all the devices, turn on the MASTER first, then turn on the playback devices (such as
amplifiers). When turning off, turn off playback device first, and then the HUSH-I PRO.
3. Recommend using the power supply that is equipped with the HUSH-I PRO, because mismatches and noise may occur when
using other power supplies.
4. The output must use 1/4"mono shielded audio cables. High-quality audio cables ensure clean and stable signal transmission.
5. OTG:
1) IOS system compatible with the phone's built-in camera for internal recording.
2) Some Android phones may require the use of third-party camera software for internal recording. If third-party camera
software fails to enable internal recording, it indicates the phone may not support OTG recording function.
3) Some data cables may not support OTG (charging only, no data transfer), try replacing the data cable.
4) For some Android phones, OTG functionality needs to be enabled in the phone's system settings.
MODULE DETAILS
1. BYPASS Mode
The Bypass mode can be activated by rotating the "EDIT" button to Level 1.
2. Select Presettings
The preset selection can be activated by rotating the "EDIT" button to Level 2; in this mode, you may
select presettings by rotating the "SELECT" button, and the presettings selected will be displayed on
the screen P#. The preset volume output may be changed by regulating the "Value" button.
Reset: Shortly press the Bluetooth button to restore the preset volume value to 80%.
3. Effect Chain Module
● MUL Module
The MUL (Multi) module may be activated by rotating the "EDIT" button to Level 3. You may switch to
diverse effects by rotating the "SELECT" button. The factory settings include three mixed effects:
Overdrive, Compressor, and Booster. The effect output values may be changed by regulating the
"Value" button.
Reset: Shortly Press the Bluetooth button to restore the effect value to 30%.
● MODULATION Module
The Modulation module may be activated by rotating the "EDIT" button to Level 4. You may switch to
diverse effects by rotating the "SELECT" module. The factory settings include five modulation
effects: Chorus, Phaser, Tremolo, Flanger, and AutoWah. The effect output values may be changed
by regulating the "Value" button.
Reset: Shortly Press the Bluetooth button to restore the effect value to 20%.
6