Publicidad
Idiomas disponibles
Idiomas disponibles
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Operation
The cordless impact screwdriver has clockwise/anti-
clockwise rotation, a ¼ inch hexagon socket bit mount
and an LED work lamp.
Please refer to the following descriptions for the func-
tion of the controls.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
8.1
Mounting the belt clip (9)
1. During work breaks, the product can be hooked on-
to the belt with the integrated belt clip (9).
2. Screw the belt clip (9) with the screw (10) to the
right or left screw-on point on the product, as re-
quired. Use a Phillips screwdriver for this (not in-
cluded in the scope of delivery).
Note:
Make sure that the product is switched off and secured
against being switched on.
8.2
Inserting/removing the battery (3)
in the battery mount (4) (Fig. 1, 2)
Inserting the battery
1. Put the rotational direction switch (8) in the middle
position (lock).
2. Push the battery (3) into the battery mount (4). The
battery (3) clicks into place audibly.
Removing the battery
1. Press the unlock button (5) of the battery (3) and re-
move it from the battery mount (4).
8.3
Inserting/removing the tool
attachment (Fig. 1)
CAUTION
Keep your hands away from the tool attachment
when the product is in operation.
Note:
* = not included in the scope of delivery!
1. Insert a tool attachment* into the tool receiver (1).
2. To insert the tool attachment*, pull the locking
sleeve (2) back and allow the attachment tool* to
engage.
3. To remove the tool attachment* again, pull the lock-
ing sleeve (2) back and remove the attachment
tool*.
8.4
Test run (Fig. 1)
Note:
Before the first work and after each tool attachment
change, carry out a test run without load. Switch off the
product immediately if the tool attachment runs out of
round, there is considerable vibration or abnormal nois-
es are heard.
www.scheppach.com
GB | 23
Publicidad
