cecotec CONGA CARPETCLEAN 10000 EASYHOME Manual De Instrucciones página 40

ENGLISH
6. TROUBLESHOOTING
If you observe any problem, carefully read this manual and try any possible solutions before
contacting the official Cecotec Technical Support Service.
Problem
The power button has
been pressed, but the
appliance does not work
When you press the spray
button, little or no water
comes out
It does not vacuum, or it is
too weak
40
CONGA CARPETCLEAN 10000 EASYHOME
Possible causes
The plug is not connected
correctly or is loose, so it
does not make contact.
The internal line or power
cord are broken.
The appliance overheats
and it activates the
protective device.
The nozzle is clogged.
The bracket or pump are
damaged.
You did not press the power
button.
The waste-water tank is
full, which activates the
float valve.
The hose does not work
properly.
The waste-water tank is not
correctly installed.
The air inlet sponge is
blocked.
Possible solutions
Turn off the appliance and
connect it again to the mains.
Contact the official Cecotec
Technical Support Service.
Read the instructions on the
protective device.
Remove the suction nozzle
and clean it with water.
Contact the official Cecotec
Technical Support Service.
Press the power button.
Empty the waste-water tank
and use it again.
Check the hose is not cracked,
broken, or clogged.
Install the waste-water tank
correctly.
Clean or replace the sponge.