Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACE SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and
runs better, Set spark plug gap at
0,025 inch. Ignition timing is fixed and
nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion RCJ-GY
spark plug and tighten securely with
a 314 inch socket wrench.
4. Reinstall the spark plug boot.
REPLACING
THE LINE
Pre-wound
spools offer the most con-
venient method for replacing line and
ensuring optimum performance.
• Replacement spools are color-coded
to ensure use of the correct spool with
your unit.
Be sure to use the same
color spool as the existing spool.
NOTE: Always clear dirt and debris
from cutting head components
when
performing any type of maintenance.
• Hold spool and unscrew cap by turn-
ing in the direction shown on top of the
cap.
• Remove line guide ring and spool.
Line guide ring
Use a pre-wound
spool or refill spool
with line. If using a pre-wound
spool,
remove tape strip from line and spool.
REFILLING THE SPOOL WITH LINE
_]IbWARNING:
Use only 0.080" (2
mm) diameter round line. Other
sizes and shapes of line will not ad-
vance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
1. Cut a length of 30 feet of 0.080" (2
mm) diameter round Craftsman
brand line.
Spool
2. Insert one end of line into center
cavity of empty spool.
Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3. Continue feeding line into spool,
leaving 4 - 6 inches (10 - 15 cm)
unwound from center of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring
Replacement Spool
3. Rest guide ring on spool and place
line through slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm)
from center of spool.
4. Ensure line remains in slot while
screwing cap on to the shaft.
Only tighten cap hand tight!
10
Publicidad
