Publicidad
Idiomas disponibles
Idiomas disponibles
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP-
ERATIONsection.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto bolt.
Shield
_Slot
Xk__k_
Bracket
•
ootg
KNOW YOUR TRIMMER
READTHiS INSTRUCTIONMANUALAND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrationswith your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Assist Handle
Muffler
ON/OFF
Trigger
Switch \
Spark Plug
Sta er r\' J'k"Z
_4---'-
FCri_ke; Bi;;r
FFi_llaMp
x
ON/OFF SWITCH
The ON/OFF switch is used to stop en-
gine. To stop the engine, move switch
to the OFF position.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
Tube
7
Trimmer
Head
Edge
Guide
Shield
l
meLimiter
Blade
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position, After the em
gine attempts to start, move the choke
lever to the HALF CHOKE position. Once
engine has started, move the choke le-
ver to the OFF CHOKE position.
EDGE GUIDE
The EDGE GUIDE protects the unit
from contacting the ground during
edging.
BEFORE STARTING ENGINE
_IbWARNING:
Be sure to read
the fuel information
in the safety rules
before you begin, If you de net
understand the safety rules, de not
attempt to fuel your unit. Call
1-800-235-5878.
FUELING ENGINE
_11_ WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline, Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled
5
Publicidad
