Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing Cord Cover
1.
Run power and signal cords through notches. To prevent unwanted interference, route the power
cord through the lowest notch (see image 1 below).
2.
Place the cord cover over the cords being careful not to pinch any of the cords. Loosely install
six M5 hex cap screws then tighten screws on the cord cover using 3mm allen wrench until the
gasket on the cover is fully compressed to the cord gasket.
3.
Replace the rear cover plate ensuring that the cords are running through the notches on the
display and not getting pinched. Fasten the two hex screws on the rear cover plate to secure it
in place using 3mm allen wrench. Ensure that rear cover plate is fully compressed to the back of
the display.
1
Notch.
Power cord.
3
Do not overtighten screws.
• Ensure cord bend radius does not exceed limits set by the manufacturer.
• Ensure cords are seated properly in the cable channels to avoid potential
damage to cords when rear cover plate is installed.
• Do not remove lanyard that connects the rear cover plate to the display.
• Ensure cables exiting input compartment are routed downward when
installing display in portrait orientation. If the installation requires the
cabling to be routed upward, ensure that the cables are routed with a drip
loop.
2
Failure to follow these instructions can result
in the product being damaged or destroyed,
voiding the warranty.
Optional: Cable management.
CAUTION
2022-01-18
12
M5 hex cap screw.
CAUTION
#:180-9168-2
E
(2022-08-31)
Publicidad
